Cisco 200-601 Exam PDF Questions

DumpsSchool Cisco 200-601 IMINS2 exam questions provide updated knowledge which Administrators, control system engineers and network engineers to pass the CCNA Industrial 200-601 Certification exam.

Try it Latest DumpsSchool 200-601 Exam dumps. Buy Full File here: (70 As Dumps)

Download the DumpsSchool 200-601 braindumps from Google Drive: (FREE VERSION!!!)

Question No. 1

Your supervisor calls you and tells you that one of the Stratix 5700 switches is not assigning all CIP explicit messages to the proper QoS queue. The switch was deployed with the ab-global macro and CIP explicit messages were previously being assigned to the proper QoS queue. You suspect the access-lists associated with the ab-global macro have been changed. Look at the following access list from the switch configuration:

access-list 101 permit udp any eq 2222 any dscp 55

access-list 102 permit udp any eq 2222 any dscp 47

access-list 103 permit udp any eq 2222 any dscp 43

access-list 104 permit udp any eq 2222 any

access-list 105 permit udp any eq 44818 any

access-list 105 permit tcp any eq 44816 any

What needs to be done to fix the above access list?

Answer: C

Question No. 2

Which five are characteristics that describe Cisco Industrial switches? (Choose five)

Answer: A, B, C, E, F

Question No. 3

Refer to the exhibit.

L3SW1 has a spanning-tree priority of 8192 set on VLANs 1, 300, and 301, and these VLANs are configured on and trunked between all switches. Executing the command show spanning-tree blockedports on L2SW5 results in:

L2SW5# show spanning-tree blockedports

Name Blocked Interfaces List

——————– ————————————

VLAN0001 Gi1/1

VLAN0300 Gi1/1

VLAN0301 Gi1/1

An additional VLAN, VLAN302, is defined on all switches and trunked between them. VLAN302 access ports are set up on each of the switches and PLC#1, I/O#1, and the PanelView are attached. You expect the new VLAN to be listed as blocked on interface GigabitEthernet1/1 of L2SW5 but it is not. The three new devices are able to communicate with each other.

After executing the same command on all switches you see this output on L2SW4:

L2SW4# show spanning-tree blockedports

Name Blocked Interfaces List

——————– ————————————

VLAN0001 Gi1/2

VLAN0300 Gi1/2

VLAN0301 Gi1/2

Why is VLAN302 forwarding on L2SW5 interface GigabitEthernet 1/1 and L2SW4 interface GigabitEthernet 1/1 and 1/2?

Answer: C

Question No. 4

Which CLI command will display IGMP snooping information in a Cisco IE2000 or Stratix 5700 switch?

Answer: C

200-601 Dumps Google Drive: (Limited Version!!!)

Exam Vendor: Cisco dumps

Facebook Comments