CCNP Switch 300-115 Exam Questions and Answers PDF

By using this knowledge of DumpsSchools 300-115 exam questions, a candidate can pass the exam in the first attempt.

Try it Latest DumpsSchool 300-115 Exam dumps. Buy Full File here: https://www.dumpsschool.com/300-115-exam-dumps.html (598 As Dumps)

Download the DumpsSchool 300-115 braindumps from Google Drive: https://drive.google.com/file/d/1uXOJ4P6dTD5Y0yHTh4idgOX6UhoLLQIA/view (FREE VERSION!!!)

Question No. 1

A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?

Answer: A

Question No. 2

Behavior of an access port when a tagged packet is received other than the

access VLAN value.

Answer: D

Question No. 3

What is the virtual mac address of HSRP group 1?

Answer: B

Question No. 4

When port security is configured on a switch, which violation mode is the default?

Answer: A

Question No. 5

Which switch is chosen as the stack master during a stack master election or re-election?

Answer: D

Question No. 6

Refer to the exhibit.

Which two statements about the network environment are true? (Choose two)

Answer: C, D

Question No. 7

Which two operational attributes can be checked for EtherChannel ports that are in err-disabled state? (Choose

two.)

Answer: A, E

Question No. 8

Which two statements about the LACP port priority of a device are true? (Choose two.)

Answer: A, B

Question No. 9

Which two statements are true about recommended practices that are to be used in a local VLAN solution design where layer 2 traffic is to be kept to a minimum? (Choose two.)

Answer: B, D

Question No. 10

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.

* DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

* DSW2 – primary device for VLAN 103 and VLAN 104

* A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

During routine maintenance, GigabitEthernet1/0/1 on DSW1 was shut down. All other interfaces were up. DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthemet1/0/1 on DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be done to make the group for VLAN 101 function properly?

Answer: A

Question No. 11

In which EtherChannel mode does a port receive and respond to PAGP messages without initiating EtherChannel communication?

Answer: C

Question No. 12

Which two commands enable loop guard on a Cisco switch? (Choose two.)

Answer: C, E

Question No. 13

How many active virtual gateways can each GLBP group support?

Answer: C

300-115 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1uXOJ4P6dTD5Y0yHTh4idgOX6UhoLLQIA/view

Related Certification: Cisco dumps

Facebook Comments